We were asked to polish this marble floor in Eaton Square which is in Belgravia one of the most historic residential parts of London, a short distance from Buckingham Palace and Knightsbridge.
Cleaning a Marble Tiled Floor
There were a lot of scratches in the Marble floor and it was also looking dull, so we set about first by giving it a good clean using Tile Doctor Pro-Clean which is an strong alkaline product designed for use on stone floors. It’s important to clean the floor before polishing to ensure there’s no dirt or grit on the floor which might get ground into the floor during polishing making the problem worse.
Polishing Marble Tiles
Once the floor was clean we started the polishing process with a Red Burnishing pad fitted to a rotary machine, the pads are diamond encrusted and can remove deep scratches. We went over the floor carefully covering every tile four times and then followed up with the white, yellow and then green polishing pads, each one polishes the floor to a higher degree. The next step was to apply Tile Doctor Shine crystallising powder with a little water polished in with our polishing machine fitted with a natural fibre pad; this step gives the floor a tough durable finish. The floor was then thoroughly rinsed to remove any residues left on the floor all before giving it a final re-polish to bring out a deep high shine.
We were asked to visit a prestige car showroom near Weybridge in surrey to see what could be done to improve the appearance of the Porcelain Tiles in the showroom. As well as foot traffic the floor also had to cope with the rubber from car tyres; naturally they had been cleaning the floor regularly themselves but were not happy with the results.
Cleaning Porcelain Tiles
Porcelain is quite a durable material that likes ceramics don’t usually need a sealer so we prescribed a Deep Clean was in order and set about scrubbing the floor using Tile Doctor Pro-Clean which is a strong alkaline cleaning product specially designed for use on Tile, Stone and Grout where acidic cleaners can cause damage. The solution was scrubbed in using a rotary machine fitted with a black scrubbing pad and then thoroughly rinsed down. I should point out a wet vacuum machine comes in very handy here for removing the liquids from the floor. When it had dried I buffed it up using a white buffing pad.
It’s difficult to see the improvement from the photographs but I can tell you the owner was really pleased with the result as were some customers who came in when we were finishing up.
This Quarry Tile floor was found under carpeting at a school in Leatherhead, Surrey during a refurbishment; you can see from the photograph what a terrible state it was in however the school was keen to keep the tiles and we were brought in to restore them.
Cleaning Quarry Tiles
There was a lot of dirt on the tiles so a strong solution of Tile Doctor Pro-Clean was applied to the floor and left to soak in for around 20 minutes; Pro-Clean is a multipurpose alkaline cleaning product designed specifically for cleaning tile and stone. The floor was then scrubbed using a rotary machine fitted with a black scrubbing pad and then thoroughly rinsed with water which was removed using a wet vacuum. Once the Quarry tiles were dry it was possible to spot the areas in need of further attention and these were scrubbed by hand together with more Pro-Clean.
Sealing Quarry Tiles
Once happy with the floor it was left to dry off overnight and we came back the next day to seal it with six coats of Tile Doctor Seal and Go which will provide future surface stain protection and also leaves a nice deep low sheen. The builders working on the refurbishment couldn’t believe the finish, I must admit looking at the photographs it was quite a transformation.